Toddleroo by North States Wide Portico Arch Gate Instructional Video

Toddleroo by North States Wide Portico Arch Gate Instructional Video


“music” This installation video is a supplement
to our North States Wide Portico Arch Gate instructions. Some of the unique
features of the Wide Portico Arch Gate are its ability to be used in an opening
that has finishing trim it can fit bigger openings with the provided
extensions it can be installed with the pressure mount or cups for additional
stability open the gate fully and it will stay
open for easy passage it can be positioned to swing closed automatically
when required and there is extra security when enabling the dual locking
feature rotating the latch 90 degrees away from a present child as you remove
the contents you’ll notice that the upper part of the gate is pre-tensioned
to compress into the opening where it will be used you’ll find the gate comes
with additional extensions and everything you need to accommodate
openings as wide as 46.8 inches you can also purchase additional extensions to
fit even larger openings to install measure the space where you intend to
install the gate and determine if extensions will be needed and which ones
will be used the extensions are added by inserting their support pegs into the
channels of the gate first remove the protective bushings marked remove from
the gate and the extensions to be used add the extensions by sliding their
support pegs into the open channel to attach them to the gate then insert the
tension knob bushings and tension knobs into the outside channels in preparation
for mounting in the opening guide the gate into the opening and center the
gate by extending the tension knobs starting at the bottom turn the tension
knobs to extend the paths if you can do both at the same time to make equal
adjustments or alternate a turn left then right repeating this until the gate
is firmly set once that’s complete align the release button and the upper latch
set at the top of the gate then extend the top paths just as you did on the
bottom for additional stability you can install the provided mounting cups
attaching them with the two sided tape or screwing them into position
when you’re done the gate should be centered in your opening with similar
distances on each side and there should be sufficient pressure on the tension
knob pads to hold it firmly in place to operate the gate push the release button
and lift the door to swing it open the gate release should open and close
easily clicking firmly into place but not be so tight that it doesn’t latch
automatically simply readjust the tension pads for proper fit if you’d
like to temporarily remove the gate from the opening simply loosen the tension
pads. The Wide Portico Arch Gate from North States. “music”

Leave a Reply

Your email address will not be published. Required fields are marked *