Wiring a Square D™ 9013 Power Pressure Switch | Schneider Electric Support

Wiring a Square D™ 9013 Power Pressure Switch | Schneider Electric Support


wiring the 1913 simple tasks the first thing to remember is to turn off power and do this without power applied for the turtles we’re going to cover under the cover you’ll notice four terminal screws we normally wire the incoming power to the far outside terminals black on on one end and red on the other that leads the two center screws for the wires that come from the pump itself we can match the black to the black we match the red or white to the other and we have therefore black black red red or black black white white whatever the wiring color is this provides either single-phase or three-phase wiring and both are essentially the same with the idea of three-phase having a third leg this part straight through you

6 thoughts on “Wiring a Square D™ 9013 Power Pressure Switch | Schneider Electric Support

  1. Okay, I have an old 10-5psi switch, is it possible to exchange the
    springs and put these on a 60-40psi switch? so I now have a new 10-5psi
    switch.

Leave a Reply

Your email address will not be published. Required fields are marked *